3D printing (book exam) (5 cr)
Code: 3K3124OJ-19011
General information
Enrollment
02.10.2023 - 31.12.2023
Timing
01.01.2024 - 31.05.2024
Credits
5 op
Virtual proportion (cr)
5 op
Mode of delivery
Distance learning
Unit
Bachelor of Engineering, Mechanical Engineering
Teaching languages
- Finnish
Seats
0 - 20
Degree programmes
- Degree Programme in Mechanical Engineering
Teachers
- Ari Pikkarainen
Responsible person
Ari Pikkarainen
Objective
Student learns the basics of additive manufacturing and the applications via book exam.
This course does not contain any teaching or laboratories. It provides theoretical information about 3D printing required in future practical 3D printing work.
Content
The student gets to know the material and performs the exam in Moodle on given time (to be agreed with the participants).
Topic that are included:
- Introduction to AM and basic principles
- General additive manufacturing process
- Different AM technologies (VAT photopolymerization, powder bed fusion, extrusion based systems, material jetting, binder jetting, direct energy deposition, sheet lamination). Focused on FDM-technology.
- Post-processing of the print
- DFAM (Design for Additive Manufacturing)
- AM product design process and printing process chart
Location and time
The exam is on xx.xx.xxx.
You can select the time between these dates
When you open the exam during that time, you will have 3 hours to do the exam.
You have only one attempt.
Materials
HUBS Knowledge Base: https://www.hubs.com/knowledge-base/ Hubs 3D Printing Guide (https://www.hubs.com/guides/3d-printing/) Support material in Moodle (2 PDF´s)
Teaching methods
The exam will be held as a Moodle exam in Spring 2024.
The Moodle site will appear closer to the exam time.
The material and information can be found from the Moodle site, found from Peppi "Learning environments".
Topic that are included:
- Introduction to AM and basic principles
- General additive manufacturing process
- Different AM technologies (VAT photopolymerization, powder bed fusion, extrusion based systems, material jetting, binder jetting, direct energy deposition, sheet lamination). Focused on FDM-technology.
- Post-processing of the print
- DFAM (Design for Additive Manufacturing)
- AM product design process and printing process chart
Employer connections
-
International connections
The exam is in English
Completion alternatives
-
Content scheduling
The exam will be held on Spring semester 2024
Further information
-
Evaluation scale
H-5
Assessment methods and criteria
Evaluation 1 - 5 based on the exam results.
Qualifications
-