3D printing (book exam) (5 cr)
Code: 3K3124OJ-19007
General information
Enrollment
01.10.2021 - 07.01.2022
Timing
01.01.2022 - 31.05.2022
Credits
5 op
Virtual proportion (cr)
5 op
Mode of delivery
Distance learning
Unit
Bachelor of Engineering, Mechanical Engineering
Teaching languages
- Finnish
Degree programmes
- Degree Programme in Mechanical Engineering
Teachers
- Ari Pikkarainen
Responsible person
Ari Pikkarainen
Student groups
-
K52K19S
-
KA52K19S
Objective
Student learns the basics of additive manufacturing and the applications via book exam.
This course does not contain any teaching or laboratories. It provides theoretical information about 3D printing required in future practical 3D printing work.
Content
The student gets to know the material and performs the exam in Moodle on given time (to be agreed with the participants).
Topic that are included:
- Introduction to AM and basic principles
- General additive manufacturing process
- Different AM technologies (VAT photopolymerization, powder bed fusion, extrusion based systems, material jetting, binder jetting, direct energy deposition, sheet lamination). Focused on FDM-technology.
- Post-processing of the print
- DFAM (Design for Additive Manufacturing)
- AM product design process and printing process chart
Location and time
The exam is on 25.4.-1.5.
When you open the exam during that time, you will have 3 hours to do the exam.
You have only one attempt.
Materials
HUBS Knowledge Base:
https://www.hubs.com/knowledge-base/
3D Hubs 3D Printing Guide (https://www.hubs.com/guides/3d-printing/)
Teaching methods
The exam will be held as a Moodle exam. The material and information can be found from the Moodle site, found from Peppi "Learning environments".
Topic that are included:
- Introduction to AM and basic principles
- General additive manufacturing process
- Different AM technologies (VAT photopolymerization, powder bed fusion, extrusion based systems, material jetting, binder jetting, direct energy deposition, sheet lamination). Focused on FDM-technology.
- Post-processing of the print
- DFAM (Design for Additive Manufacturing)
- AM product design process and printing process chart
Employer connections
-
International connections
The exam is in English
Completion alternatives
-
Content scheduling
The exam will be held on Spring semester 2022.
Further information
-
Evaluation scale
H-5
Assessment methods and criteria
Evaluation 1 - 5 based on the exam results.
Qualifications
-